FUEL PUMP This excellent quality pump is now available in two versions.
This one (#FPUMP) is a 'Pressure' version for mounting near the fuel tank.
The other(#FPUMPS) is a 'Suction' version best used for installation in your engine bay.
12 Volt. Flow rate 125 Lt/hr. Integral 8mm swivelling inlet & outlet unions. Size 73mm x 128mm.
Mounting bracket & fixing screws included.
Made in Germany.
Not suitable for Bio Diesel. ECE Approved
NOTE: We always recommend the use of a pre-filter with all fuel pumps. Mount vertically with inlet/outlet at the top.
#FPUMP Pressure 4.2 psi. Suction -1.4 psi.
IMPORTANT NOTE: ALL FUEL PUMPS MUST BE FITTED WITH A PRE-FILTER ON THE INLET SIDE. RETURNED PUMPS WILL NOT BE REPLACED OR REFUNDED IF FOUND DAMAGED DUE TO DEBRIS.
SPECIAL NOTE: WHEN ADJUSTING THE ANGLE OF THE INLET AND OUTLET, LIFT THEM CLEAR OF THE PUMP AND REFIT THE O RING TO THEM BEFORE TURNING AND REWFITTING TO AVOID DAMAGE TO THE 'O' RING.
DO NOT OVERTIGHTEN THE OUTLET RETAINING SCREW OR YOU WILL SPLIT THE CASING
FUEL PUMP #FPUMP
