AUTOMATIC LIGHTS ON / OFF
This little device has a remote photosensor and a 10 Amp solid state,
12 volt relay which will automatically switch on your sidelights and/or dipped beam
when ambient light inside the vehicle drops to a preset level.
Sensor cable 1.5mtrs long cable.
CONNECTIONS
EARTH - Bolt through the metal relay base to a clean -12 volt, earth point
on your vehicle or connect earth to the base with a ring terminal.
RED - +12 Volt Ignition feed in.
BLUE - out to switch on your dipped beam via a relay. 5 Amp (60 Watts) max.
YELLOW - +12v out to side lights. 5 Amp (60 Watts) max.
GREEN - connect to the live feed on your sidelight switch. 10 Amp (120 Watts) max.
NOTE: Do not mount the sensor in direct daylight.
Mount inside the vehicle.
Experiment with the position before final fitting.
A 12-turn potentiometer inside the case
allows adjustment of the darkness threshold but it’s
supplied setting is fine for most applications.
IMPORTANT NOTE: THE ENGINE MUST BE RUNNING AND THE ALTERNATOR
CHARGING FOR THIS DEVICE TO ARM AND WORK PROPERLY.
IF YOU ARE BENCH TESTING THE UNIT YOU MUST
HAVE A 13.3 volts POWER SUPPLY. IT WILL NOT WORK ON 12 VOLTS
SEE OUR YOUTUBE VIDEO FOR BENCH DEMO AND WIRING INFO.
AUTOMATIC LIGHTS ON and OFF CONTROLLER #AUTOLTS
